AQUATERM 63M SOCKET FUSION DIE MANUAL
The JAC-063 is a Manual Socket Fusion Welder for heat fusing Socket Fusion style fittings and pipe. Note that the Butt fusion bead will not need to be protected from UV exposure. JAC-063 SOCKET FUSION WELDER 1/2' - 2' ND 20MM -63MM. There may still be some remains of HDPE on the heating iron after the weld is complete, so it would be prudent to clean the iron with a lintfree cloth after each weld, or chamfer the pipe end slightly to avoid HDPE contact with the iron. It will shift out the welding zone during the bead-up/adjustment phase.
Butt Fusion When performing butt fusion of the UV pipe, there is no need to remove the HDPE outer layer. The chamfer tool is put on the end of the pipe and turned. The following are proper procedures for using the chamfer and cold ring tools for socket fusion. Note that the couplings and fittings will not need to be protected from UV exposure. Aquatherm does not endorse the use of the cold ring and chamfer tools, but if their use is desired, Aquatherm does not object. Refer to the Installer Manual for more detailed instructions. Socket Fusion When socket fusing UV pipe, the HDPE outer layer must be peeled back to at least the point of insertion into the socket. When fusing Aquatherm UV pipe some special considerations need to be observed. Each of these pipes have a black HDPE outer layer (approximately 1 mm thick) that covers the pipe offering protection of the pipe from damaging UV rays. March 30th, 2016 TECHNICAL BULLETIN: 201603C-AQTTBĪquatherm offers Ultraviolate (UV) resistant piping in SDR 7.4 MF Faser Green Pipe, SDR 7.4/SDR 11 MF Faser Blue Pipe, and SDR 17.6 MF Faser Blue Pipe.
0 kommentar(er)
